Trick or Treat Holders

I wanted to do something fun for my daughters class this year.  So, my wheels were spinning.  Then I thought – how about a few sucker holders!

This project is for all levels.

Skill Level- 1 Button

Materials:

• felt
• ribbon trim
• snaps (or markers, paint)
• Tulip Spray Glitter
• Tulip Glitter
• Aleene’s Fabric Fusion Glue
• stuffing *I used Pellon Perfect Loft

Click Halloween Treat Pattern to download pattern file.

Instructions:

Ghost-

1. Pin pattern and cut 2 layers of felt for each treat holder.  Then cut a small strip from the scraps about 1 1/4″ x 3/8″. (this will hold the lollipop later)
2. Since I wanted my ghost to shimmer, I sprayed on some Tulip Glitter Spray Paint.  (I did this inside a box to avoid any over spray)
3. While drying, I tacked my lollipop holder in place with a straight stitch on the back of ghost. After it dried, I attached my snap eyes.  You can create the eyes with a marker, felt or even paint.
4. Fold a piece of ribbon in half and sandwich at the top edge. Pin front and back together.
5. Edge stitch all around outside leaving a small opening for stuffing.
6. Stuff and stitch closed.

1. Pin pattern and cut 2 layers of felt for each treat holder.  Then cut a small strip from the scraps about 1 1/4″ x 3/8″. (this will hold the lollipop later)
2. Fold a piece of ribbon in half and sandwich at the top edge. Pin front and back together.
3. Starting below the brim of hat; stitch all around outside edge.
4. Stuff and stitch closed.  Then edge stitch all around the edge of hat.
5. Add glue and sprinkle with glitter.  Allow to dry.

 

 

Aren’t they cute? I am going to stitch together a bunch of treat holders and use them as goodies for Halloween.  I think they would even make cute party favors.